1. Punch workers can operate independently only after learning, mastering the structure and performance of the equipment, being familiar with the operating procedures and obtaining an operating license. the 2. The CNC turret punching machine is operated and maintained by a special person. The operator is familiar with the structure and performance of the punching machine, strictly operates and uses it in accordance with the instruction manual and operating procedures, and strictly prohibits the use of equipment beyond the specifications. Non-operators are not allowed to start and operate the punching machine without authorization.

2. The CNC turret punching machine is operated and maintained by a special person. The operator is familiar with the structure and performance of the punching machine, strictly operates and uses it in accordance with the instruction manual and operating procedures, and strictly prohibits the use of equipment beyond the specifications. Non-operators are not allowed to start and operate the punching machine without authorization. the

3. Correctly use the protection and control devices on the equipment, and do not dismantle them arbitrarily.

4. Check whether the transfer, connection, lubrication and other parts of the punch press and the protective safety device are normal, and the screws for the mold are firm and must not be moved. the
5. The punch press should run dry for 2-3 minutes before working, check the flexibility of the foot brake and other control devices, and use it after confirming that it is normal. the
6. Pay attention to lubrication before driving, and remove all floating items on the bed. the
7. When the punch is moved or punched, the operator should stand properly, and the hands and head should keep a certain distance from the punch. 8. When punching or making short and small workpieces, special tools should be used, and materials should not be directly fed or picked up by hand.
9. The area around the press should be kept clean and the roads should be clear. It is strictly forbidden to stack products and other items in the dangerous area. the
10. Overload stamping is strictly prohibited, and operators should strictly implement this standard during processing. the
11. Check the air pressure value before work, if it does not reach the specified pressure value, you cannot drive. the
12. Before starting the machine, open the discharge gate of the oil-water separator to release accumulated oil and water, and replace the filter material of the oil-water separator regularly according to specific conditions. Check the amount of oil in the lubricator, and always maintain sufficient oil storage.
13. The mold should be tight and firm, touch up and down to ensure the correct position, and move the punching machine by hand to test punch (empty car) to ensure that the mold is working in a good condition. the
14. The workshop has special personnel for programming and special personnel to check. Before program input, check whether the knobs of each program switch row are placed correctly.